Posted: Sat Jan 31, 2009 12:16 pm Post subject: Easily debug error messages in SAP processes
Sometimes, an SAP process will stop working with an error message, or an abend. Unlike with a dump, it can be difficult to find exactly where the problem occured. What you should do, is get the technical name and number of the message - e.g. RS 100. Set a breakpoint at the start of the process (or run the process with the debugger switched on). As soon as the debugger is in some abap code, set a watchpoint for sy-msgno. In this example, you should set a watch point for sy-msgno = 100. Then hit F8.
The process will continue to run until sy-msgno has the value 100.
Check that the message ID is correct, according to the message - RS in this example. If it is, then you are at the place where the error occurs. You can usually back trace a few steps to find out precisely what was causing that error to be triggered.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum You cannot attach files in this forum You can download files in this forum
All product names are trademarks of their respective companies. SAPNET.RU websites are in no way affiliated with SAP AG. SAP, SAP R/3, R/3 software, mySAP, ABAP, BAPI, xApps, SAP NetWeaver and any other are registered trademarks of SAP AG. Every effort is made to ensure content integrity. Use information on this site at your own risk.
